ATS (Automatic transfer switch) Panels
Mains to DG Automatic transfer switch panels are used where the primary mains supply is backed up by a secondary supply forwarded to load. This type of panel is used for critical loads, such as emergency hospital, fire fighting, lifts common area load. The ATS panel monitors the mains supply and will transfer the load to the secondary supply if it should fail, or fall outside preset limits.
An adjustable delay is included when switching from primary to the secondary supply. A switch is included to allow manual switching between the primary and secondary supplies.
Features
- Over voltage, under voltage, single phase, reverse phase voltage unbalance are protection for mains supply.
- Voltage monitoring for mains.
- Select able time delay for change over.
- Available rating from 16A to 6300A.
- Indication for mains or Dg.
- Our Panel Has Been CPRI Approved.
Request a Quote
Frequently Asked Questions
A server rack is a metal frame used to house and organize servers, networking equipment, and other hardware in a data center or server room. It provides a standardized and secure mounting platform for various IT components.
The most common standard sizes for server racks are 19 inches in width, with heights measured in rack units (U). The standard height for a rack unit is 1.75 inches. Common heights include 42U and 48U, with smaller racks available for specific needs.
The 19-inch standard dates back to early telecommunication equipment. It provides a consistent and interchangeable form factor, allowing for easy integration of different components from various manufacturers.
A rack unit, often abbreviated as “U” or “RU,” is a standard measurement for the height of rack-mounted equipment. One rack unit is equivalent to 1.75 inches (44.45 mm). For example, a 2U server occupies 3.5 inches of vertical space.
Consider the number and type of equipment you plan to install. Ensure there is enough space for current and future hardware requirements. Also, factor in cooling and cable management needs when selecting the rack size.